Topic awaiting preservation: would this be 3d? (Page 1 of 1)

i did the basic blocks and circles in coreldraw 3d and finished it up in photoshop6 cause i cannot afford a high end 3d prog

is adobe dimensions any good?
www.melstudios.com/tng2.png

thanks



[This message has been edited by mel (edited 03-27-2002).]

Yes

It's very rough, and strangely coloured, and for some reason you have downwards motion blur on the rear fins and no where else, but yes, it is 3D

kool skarrz

actually its not a blur just a skewd choped up engine
if you look close youll see the engin reused on the bottom scoop as well
hey when all you got is nothing turn it into something...
i guess i could select some pixels and clear them.....and then darken up the shading on them so they aint so blurried...

is adobe dimensions anygood?.for anything?

would anybody be so kind as to give me swift 3d it is my birthday

i read another post and somebody mentioned pov was free? where is dis???

is povlab the same thing as pov?

thanks

www.povray.org

povlab? i heard of that, but at the moment i cant remember what it is.

Why dont you get Alias

i recently checked out that free maya edition and i was kinda angry about that water-mark that is rendered in.
first they were saying its only a small little logo.
so i thought about a 50x50 logo in a corner but it is an ugly text all over the image that covers about 20% of it.

I think that povlab is a variant of povray that also uses shaders. Its not fully supported yet though.

Schitzo